English 7
Connection
REVERSE
NORMAL
PHASE
BAND REJECT
–12dB
–6dB
OFF
B.M.S.
+12dB
OFF
REMOTE
INFRASONIC
25Hz
15Hz
ON
OFF
GND
LINE OUT EXT.AMP.CONT.LINE IN
L
R
L
R
25
25
25
SPEAKER
OUTPUT
POWER IN
P.CON
BATT.
GND
FUSE(
25Ax3
)
^ (&*
!@#$ %
!Fuse (25 A ×3)@Battery terminal#Ground terminal%Speaker output terminals
As this unit accepts speakers with a
minimum impedance of 1 ohm, connect
speakers with 1-ohm or higher impedance
to these terminals.
The rated input of the speakers should be
no less than the maximum output of the
amplifier. Otherwise malfunction may
result.
^RCA cable ground lead terminal
When using an RCA cable with a ground
lead attached, connect the ground lead to
this terminal.
&LINE IN terminal*LINE OUT terminal
The signal that’s input from the line input
terminal is output.
$Power control terminal
Controls the unit ON/OFF.
Controls the unit power. Be sure to connect it
with all the systems.
(EXT.AMP.CONT. (externalamplifier control) terminal
Controls the B.M.S. Only Kenwood center
unit models sold in 1999 or later with a
"EXT.CONT."/"EXT.AMP.CONT." wire
attached can be used.
Also, a maximum of 3 power amplifiers can
be operated at the same time.
There are cases when operation may not be
possible due to wiring wire type and length.
NOTE
NOTE
2CAUTION
■Terminal names