4English
Controls / Indicator
ON
OFF
INFRASONIC FILTER
LPF
OFF
HPF
B.M.S.
+12dB
OFF
REMOTE
OPERATION
MONO(L ch)
STEREO
GND
LINE OUT EXT.AMP.CONT.LINE IN
L
R
L
R
ON
OFF
INFRASONIC FILTER
LPF
OFF
HPF
B.M.S.
+12dB
OFF
REMOTE
OPERATION
MONO(L ch)
STEREO
1 2 3 4
5
6
8
9
7

5INPUT SENSITIVITY control

Adjust this control according to the pre-out
level of the center unit connected to this
amplifier.
Refer to "Specifications" on the center
unit’s instruction manual about the pre-out
level.

4OPERATION switch

This switch is used to select the operation
mode of the amplifier.

•STEREO position:

The amplifier can be used as a stereo
amplifier.

•MONO (Lch) position:

Amplifies the signal input from the left side
only. Set to this position and make bridged
connections to use as a high-power
monaural amplifier. (The input right signal is
not output.)

3FILTER switch

This switch allows to apply high-pass or
low-pass filtering to the speaker outputs.

•HPF (High-Pass Filter) position:

The filter outputs the band of higher
frequencies than the frequency set with the
HPF FREQUENCY control.

•OFF position:

The entire bandwidth is output without
filtering.

•LPF (Low-Pass Filter) position:

The filter outputs the band of lower
frequencies than the frequency set with the
LPF FREQUENCY control.
The speaker output is automatically turned
monaural (L+R) and the bass boost function
is activated.

9HPF FREQUENCY control

Sets the cutoff frequency when the FILTER
switch is set to HPF.

8LPF FREQUENCY control

Sets the cutoff frequency when the FILTER
switch is set to LPF.

1INFRASONIC FILTER switch

When this switch is ON, the frequencies
which are below the audible range and
therefore inaudible are cut off so that the
quality of the audible frequencies can be
improved.

2B.M.S.(Bass management system)

switch

Bass boost centered on the frequency set
by the B.M.S. FREQUENCY control.

•+12 position:

Bass boost +12 dB

•OFF position:

Bass boost OFF

•REMOTE position:

Controls the B.M.S. from the Kenwood
center unit. (Refer to page 5)

6B.M.S. FREQUENCY control

When the B.M.S. switch is set on "+12dB"/
"REMOTE" the emphasized center
frequency is adjusted.

7V-COLOR (Variable color) button

Select the ON color for the indicator.
Every time the button is pressed, 7 fixed
colors and the variable color change.
The color can’t be set when the indicator is
blinking.
NOTE