English 7

MONO(Lch)STEREO
OPERATION
A.CH B.CHFILTER
A.CH HPF
FILTER FREQUENCY(Hz)
LPF
OFF
HPF
HPF
OFF
B.M.S.
+12dB
OFF
REMOTE
INPUT SELECTOR
GND
EXT.AMP.CONT.
LINE IN
L
R
L
R
ABSUB
BABA A SUB
200
50
B.CH HPF
200
50
B.CH LPF
200
50
SUB.CH LPF
200
50
30
30
SPEAKER
OUTPUT
POWER IN
P.CON
BATT.
GND
FUSE(
30Ax2
)
LEFT
BRIDGED
RIGHT SUB
SUB
A
B
&@#$% ^
*)(

@Fuse (30 A ×2)

#Battery terminal

$Ground terminal

^Amplifier A/B speaker output

terminals

Stereo Connections:

When you wish to use the unit as a stereo
amplifier, stereo connections are used.
The speakers to be connected should
have an impedance of 2or greater.
When multiple speakers are to be
connected, ensure that the combined
impedance is 2or greater for each
channel.

•Bridged Connections:

When you wish to use the unit as a high-
output monaural amplifier, bridged
connections are used. (Make connections
to the LEFT channel 9and the RIGHT
channel ·SPEAKER OUTPUT terminals.)
The speakers to be connected should
have an impedance of 4or greater.
When multiple speakers are to be
connected, ensure that the combined
impedance is 4or greater.
The rated input of the speakers should be no
less than the maximum output of the
amplifier. Otherwise malfunction may result.

&Amplifier SUB speaker output

terminal

As this unit accepts speakers with a
minimum impedance of 2 ohms, connect
speakers with 2-ohm or higher impedance
to these terminals.

*RCA cable ground lead terminal

When using an RCA cable with a ground
lead attached, connect the ground lead to
this terminal.

(A.CH/B.CH/SUB.CH LINE IN

terminal

%Power control terminal

Controls the unit ON/OFF.
Controls the unit power. Be sure to connect it
with all the systems.

)EXT.AMP.CONT. (external

amplifier control) terminal

Controls the B.M.S. Only Kenwood center
unit models sold in 1999 or later with a
"EXT.CONT."/"EXT.AMP.CONT." wire
attached can be used.
Also, a maximum of 3 power amplifiers can
be operated at the same time.
There are cases when operation may not be
possible due to wiring wire type and length.
NOTE
NOTE
2CAUTION

Terminal names

Connection