7
ENGLISH
Getting started

Canceling the display demonstration

The display demonstration is always turned on unless you cancel it.
When you turn on the power (or after you reset the unit), the display shows:
[CANCEL

DEMO] \ [PRESS] \ [VOLUME KNOB]
1
Press the volume knob.
[YES] is selected as the initial setup.
2
Press the volume knob again to confirm.
[DEMO

OFF] appears.
If no operation is done for about 15 seconds or if you turn the volume knob to select [NO] in
step
2
, [DEMO

MODE] appears and the display demonstration starts.

Setting the demonstration mode

1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [DEMO MODE], then press to enter.
3
Turn the volume knob to select [ON] or [OFF].
If [ON] is selected, display demonstration starts if no operation is done for about
20 seconds.
4
Hold to finish the procedure.

Adjusting the clock

1
Press the volume knob to enter [FUNCTION] mode.
2
Turn the volume knob to select [SETTINGS], then press to enter.
3
Turn the volume knob to select [CLOCK], then press to enter.
4
Press the volume knob to select [CLOCK ADJ].
Clock hour flashes on the display.
5
Turn the volume knob to adjust the hour, then press to enter minute adjustment.
Clock minutes flashes on the display.
6
Turn the volume knob to adjust the minute, then press to confirm.
Press 4
/
ยข to move between the hour and minute adjustment.
7
Hold to finish the procedure.
Continued...
EN02-21_KDC-200U[K]1.indd 7EN02-21_KDC-200U[K]1.indd 7 4/20/12 12:56:41 PM4/20/12 12:56:41 PM