— 23—
■Removing the hard rubber frame
2When the lower level is removed, remove the upper two
locations.
The frame can be removed from the top side in the same manner.
Catch
Lock
1Engage the catch pins on the removal tool and remove the two
locks on the lower level.
Lower the frame and pull it forward as shown in the figure.
Accessory2
Removal tool
8 mm
MAX.
ø5mm ø5mm
8mm
MAX.
■Installing in Japanese-Made Cars
T: Toyota cars
N: Nissan cars
T
N
N
TT/N
Accessory4...for Nissan car
Accessory5...for Toyota car
•During installation, do not use any screws except for those provided.
The use of different screws might result in damage to the main unit.
•Damage may occur if a screwdriver or similar tool is used with
excessive force during the installations.
1Refer to the section "Removing the hard rubber frame" (page 23)
and then remove the hard rubber frame.
2Align the holes in the unit (two locations on each side) with the
vehicle mounting bracket and secure the unit with the accessory
screws.
45
Installation
Accessory6
■Screwing the Faceplate on the Unit
Never insert the taptite screw (ø4 ×16 mm) in any other screw hole
than the one specified. If you screw it in another hole, it will contact
and may cause damage to the mechanical parts inside the unit.
If you want to fasten the
faceplate to the main unit so
that it does not fall off,
screw in the provided screw
(ø4 X 16 mm) in the hole
shown below.
KDC-3020R_U.S 01.11.29 10:47 AM Page 23