English
— 18 —— 18 —
■Removing the hard rubber frame
2When the lower level is removed, remove the upper two
locations.
The frame can be removed from the top side in the same manner.
Catch
Lock
1Engage the catch pins on the removal tool and remove the two
locks on the lower level.
Lower the frame and pull it forward as shown in the figure.
Accessory2
Removal tool
Accessory2
Removal tool
Screw (M4X8)
(commercially
available)
■Removing the Unit
4Lower the removal tool
toward the bottom, and pull
out the unit halfway while
pressing towards the inside.
Be careful to avoid injury from
the catch pins on the removal
tool.
5Pull the unit all the way out
with your hands, being
careful not to drop it.
1Refer to the section “Removing the hard rubber frame” and then
remove the hard rubber frame.
2Remove the screw (M4 × 8) on the back panel.
3Insert the two removal tools deeply into the slots on each side,
as shown.
Installation
KDC-4023_U.S 02.9.26 3:09 PM Page 18