Every receivable Channel is checked for 10 seconds.
1Start Channel Scan
Press the [AUTO] button for at least 2 seconds.
The channel number display blinks.

Channel Scan

Calling up the channels in the memory.
1Select the preset band
Press the [FM] button.
2Select the key function section
Press the [NEXT] button.
Hold down on the button until the function item is not displayed
above the [2] —[5] button.
3Call up the channel
Press the desired [1] — [6] button.

Preset Tuning

3Select the key function section
Press the [NEXT] button.
Hold down on the [2] —[5] button until the function item is not
displayed above the button.
Refer to <Notes on Multi-function Key System> (page 8).
4Put the channel in the memory
Press the desired [1] — [6] button for at least 2 seconds.
The preset number display blinks 1 time.
On each band, 1 channel can be put in the memory on each [1]
— [6] button.
Only the channel number is stored. Category information is not
stored.
Putting the channel in the memory.
1Select the preset band
Press the [FM] button.
2Select the channel to put in the memory
Press the [4] or [¢] button.

Channel Preset Memory

Press the [FM] button.
Each time the button is pressed the preset band switches
between the SR1,SR2,SR3 and SR4.

Selecting the Preset Band

Entering the channel and tuning.
1Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote.
2Enter the channel
Press the number buttons.
3Do Channel Search
Press the [4] or [¢] button.
Canceling Direct Access Tuning
Press the [DIRECT] button on the remote.
•If you make no button operation for 10 seconds, the Direct Access
Tuning mode is automatically canceled.
•You can set up to Channel number 223.
•If there is no signal in the input Channel, "NO CH" appears.
•If you cannot receive any signal in the input Channel due to a bad
condition on radio wave or another problem, "Acquiring Signal"
appears.

Direct Access Tuning (Function of remote)

Sirius tuner control features
— 30—
English
KDC-MP822_U.S 02.12.11 11:23 AM Page 30