Removing the Unit

■ Removing the hard rubber frame English

1 Insert the removal tool5 deeply with the cut placed to the right to remove the upper locks at an angle as shown below.

Lock

Cut

Accessory5

Removal tool

2Engage the catches on the removal tool2 and remove the two locks on the lower level, leaving the removal tool5 inserted on the upper level.

Use the removal tool facing the side covered with the protective sheet to the faceplate.

Lower the frame and pull it forward as shown in the figure.

Catch

Accessory2

Lock

Removal tool

NOTE

You will feel (not hear) a click when the tabs lock securely.

■Removing the Unit

1Refer to the section “Removing the hard rubber frame” and then remove the hard rubber frame.

2Remove the hex head machine screw with washer (M4⋅8) on the back panel.

3Insert the two removal tools at an angle and push them deeply into the slots on each side, as shown.

Accessory3

Accessory2

Removal tool

4Push downward on the left- hand tool and the upward

on the right-hand tool, as shown, and pull the unit toward you until it is halfway out. The unit may drop if you pull it out completely.

2CAUTION

Be careful to avoid injury from the catch pins on the removal tool.

5Pull the unit all the way out with your hands, being

careful not to drop it.

— 40 —