■ Accessories
A ⋅ 1 B ⋅ 4 | C ⋅ 4 | D ⋅ 1 | E ⋅ 1 | F ⋅ 1 |
■Installation Procedure
1Removing the transportation screws Remove all 3 transportation screws for protecting the internal mechanism before you start to install the unit.
NOTE
After removing the transport screw, retain it carefully and attach it again before transporting the unit again.
2Angle adjustment switches
•The angle adjustment switches on the both side of the unit are to be set according to the angle of installation of the CD auto changer. Set both of the two switches to the same position. If the switches are not set properly, sound skip or other malfunction may occur.
•Set the angle adjustment switches with a coin or other flat object.
•Change the switch step by step by detaching and reusing the object at the end of each step.
Transportation screws
3Cover the holes indicated by 3 with the dustproof seals E. (Bottom and sides)
Use the holes marked ● to install the unit. (See page 14)
2CAUTION
Do not tighten the screw B too securely at the time of installation, but tighten it securely after having fixed the bracket A.
0
45
90
Angle adjustment switches
0
45
90
0°~5° |
|
| 40°~50° | 85°~90° |
Installation angle |
|
|
|
|
|
| 0 | 0 | 0 |
| 45 | 45 | 45 | |
|
| |||
|
|
|
| |
Angle adjustment switch position |
|
| 90 | 90 |
90 |
|
|
|
|
It is not possible to install at an angle of 40°~50° if only A is used.
6