— 27—— 27—
Make sure that the unit is installed securely in place. If the unit is
unstable, it may malfunction (for example, the sound may skip).
Metal mounting strap
(commercially available)
Self-tapping screw
(commercially available)
Firewall or metal support
Screw (M4X8)
(commercially
available)

■Installation

8 mm
MAX.
ø5mm ø5mm
8mm
MAX.

■Installing in Japanese-Made Cars

T: Toyota cars
N: Nissan cars
T
N
N
TT/N
Accessory3...for Nissan car
Accessory4...for Toyota car
•During installation, do not use any screws except for those provided.
The use of different screws might result in damage to the main unit.
•Damage may occur if a screwdriver or similar tool is used with
excessive force during the installations.
1Refer to the section <Removing the hard rubber frame> and
then remove the hard rubber frame.
2Align the holes in the unit (two locations on each side) with
the vehicle mounting bracket and secure the unit with the
accessory screws.
34
Bend the tabs of the
mounting sleeve
with a screwdriver or
similar utensil and
attach it in place.
Installation
Accessory5

■Screwing the Faceplate on the Unit

Never insert the taptite screw (ø4 ×16 mm) in any other screw hole
than the one specified. If you screw it in another hole, it will contact
and may cause damage to the mechanical parts inside the unit.
If you want to fasten the
faceplate to the main unit so
that it does not fall off,
screw in the provided screw
(ø4 X 16 mm) in the hole
shown below.
KDC-MP4023_U.S_r3.1 2002.11.14 05:14 PM Page 27