English | 11
5 Exit the Detail Audio Control mode
Press the [VOL] knob for at least 1 second.
• When the Bass Extend is set to ON, low frequency
response is extended by 20%.
• You can exit the Audio Control mode at anytime by
pressing any button except for [VOL], [ATT] and [ANG]
buttons.
Audio Setup
Setting the Sound system, such as Cross over
Network.
1 Select the source for adjustment
Press the [SRC] button.
2 Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3 Select the Audio Setup item for adjustment
Press the [VOL] knob.
Each time the knob is pressed, the items that can
be adjusted switch as shown below.
4 Setup the Audio item
Turn the [VOL] knob.
Adjustment Item Display Range
Front High Pass Filter*2"HPF" Through/40*³/60*³/80/100/
120/ 150/180/220*³ Hz
Rear High Pass Filter*2"HPR" Through/40*³/60*³/80/100/
120/ 150/180/220*³ Hz
Low Pass Filter*1,2 "LPF" 50*³/60/80/100*³/120/
Through Hz
Subwoofer Phase*1,2 "PHAS" Normal (0°)/ Reverse (180°)
Volume offset "V-OFF" –8 — ±0
Loudness "LOUD" OFF/ON
Dual Zone System*4"2ZON" OFF/ON
• Volume offset: Each source’s volume can be set as a
difference from the basic volume.
• Loudness: Compensating for low and high tones
during low volume.
When it's ON, "LOUD" indicator is ON.
• *1
You can control this item when <Switching preout>
(page 25) is set to "SWPRE SW". (Function of the KDC-
MP5028/MP528)
• *1 You can control this item when <Subwoofer
Output> (page 11) is set to "SW ON".
• *2 You can control this item when "2ZON" of <Audio
Setup> (page 11) is set to "OFF".
• *³ KDC-X589/MP5028 only.
• *⁴ The Dual Zone System can be used with the
Auxiliary input sources shown below.
- Internal auxiliary input (KDC-MP5028/MP528 only)
- Option CA-C1AX (KDC-X589 only)
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- The channel of sub source is set up by <Dual Zone
System Setting> (page 25).
- Main source is selected by [SRC] button.
- The volume of Front channel is adjusted by [VOL]
knob.
- The volume of Rear channel is adjusted by <Audio
Control> (page 10).
- The Audio Control has no effect on sub source.
5 Exit Audio Setup mode
Press [VOL] knob for at least 1 second.
Subwoofer Output
Turning the Subwoofer output ON or OFF.
Hold down on [AM] of the Control knob for at
least 1 second.
Each time the button is pressed, Subwoofer
output switches ON and OFF.
When it’s ON, "SW ON" is displayed.
• You can control this item when <Switching preout>
(page 25) is set to "SWPRE SW". (KDC-MP5028/MP528
only)
• You can control this item when "2ZON" of <Audio
Setup> (page 11) is set to "OFF".