General features

Audio Setup

Setting the Sound system, such as Cross over Network.

1Select the source to adjust Press the [SRC] button.

2Enter Audio Setup mode

Press the [VOL] knob for at least 1 second.

3Select the Audio Setup item to adjust Press the [VOL] knob.

Each time you press the knob, the item to be adjusted alternates between the items shown in the table below.

4Setup the Audio item Turn the [VOL] knob.

Adjustment Item

Display

Range

Front High Pass

"HPF"

Through/40*5/60*5/80/100/

Filter*1,3

 

120/150/180/220*5 Hz

Rear High Pass Filter*1,3

"HPR"

Through/40*5/60*5/80/100/

 

 

120/150/180/220*5 Hz

Low Pass Filter*1,2,3

"LPF"

50*5/60/80/100*5/120/

 

 

Through Hz

Subwoofer Phase*1,2,3,4

"PHAS"

Reverse (180°)/ Normal (0°)

Volume offset

"V-OFF"

–8 — ±0

Loudness

"LOUD"

OFF/ON

Dual Zone System*1

"2ZON"

OFF/ON

•Volume offset: Sets each source’s volume as a difference from the basic volume.

•Loudness: Compensates for low and high tones during low volume.

•*1 Function of KDC-X590/MP632U.

•*2 You can control this item when <Switching preout> (page 30) is set to "SWPRE SW". (KDC-MP632U only)

•*2 You can control this item when <Subwoofer Output> (page 15) is set to "SW ON".

•*3 You can control this item when "2ZON" of <Audio Setup> (page 14) is set to "OFF".

•*4 You can control this item when Low Pass Filter is not set to Through.

•*5 KDC-X590 only

•Dual Zone System

Main source and sub source (Auxiliary input) output Front channel and Rear channel separately.

-Set up the channel of sub source by <Dual Zone System Setting> (page 30).

-Select Main source by [SRC] button.

-Adjust the volume of Front channel by [VOL] knob.

-Adjust the volume of Rear channel by <Audio Control> (page 12).

-The Audio Control has no effect on sub source.

•You can use the Dual Zone System with the Auxiliary input sources listed below.

-Internal auxiliary input (KDC-MP632U only)

-Option CA-C1AX/ CA-C2AX (KDC-X590 only)

5Exit Audio Setup mode

Press the [VOL] knob for at least 1 second.

Speaker Setting

Fine-tuning so that the System Q value is optimal when setting the speaker type.

1Enter Standby

Press the [SRC] button. Select the "STANDBY" display.

2Enter Speaker Setting mode Press the [VOL] knob.

3Select the Speaker type Turn the [VOL] knob.

Each time you turn the knob, the setting alternates between the settings shown in the table below.

Speaker type

Display

OFF

 

"SP OFF"

For 5

& 4 in. speaker

"SP 5/4"

For 6

& 6x9 in. speaker

"SP 6*9/6"

For the OEM speaker

"SP OEM"

4Exit Speaker Setting mode Press the [VOL] knob.

14 English