•According to the Bass Q Factor setting value, the frequencies that
can be set in Bass Center Frequency change as shown below.
Bass Q Factor Bass Center Frequency
1.00/1.25/1.50 60/70/80/100
2.00 60/70/80/150
•When the bass extend is set to ON, low frequency response is
extended by 20%.
•Volume offset: Each source's volume can be set as a difference
from the basic volume.
•Loudness: Compensating for low and high tones during low
volume.
(KDC-MP919/X759) The graphic is displayed when
Loudness is ON, and is switched OFF when Loudness
is OFF.
5Exit Audio Control mode
Press the [AUD] button.
3Select the Audio item for adjustment
Press the [FM] or [AM] button.
Each time the button is pressed the items that can be adjusted
switch as shown below.
4Adjust the Audio item
Press the [4] or [¢] button.
Adjustment Item Display Range
Bass Center
Frequency
"Bass FRQ" 60/70/80/100 or 150 Hz
Bass level "Bass" –8 — +8
Bass Q Factor "Bass Q" 1.00/1.25/1.50/2.00
Bass Extend "Bass EXT" ON/OFF
Middle Center "MID FRQ" 0.5/1.0/1.5/2.0 kHz
Frequency
Middle level "MID" –8 — +8
Middle Q Factor "Middle Q" 1.0/2.0
Treble Center
Frequency
"TRE FRQ" 10.0/12.5/15.0/17.5 kHz
Treble level "TRE" –8 — +8
Balance "Balance" Left 15 — Right 15
Fader "Fader" Rear 15 — Front 15
Non-Fading level "NF Level" –15 — +15
Front High Pass Filter "HPF Front" Through/40/60/80/100/120/
150/180/220 Hz
Rear High Pass Filter "HPF Rear" Through/40/60/80/100/120/
150/180/220 Hz
Non-Fading "LPF NF" 50/80/120/Through Hz
Low Pass Filter
Non-Fading Phase "NF Phase" Normal (0°)/Reverse (180°)
Volume offset "Volume Offset" –8 — ±0
Loudness "LOUD" ON/OFF
— 11 —
KDC-X859_U.S_r1 01.12.10 9:40 AM Page 11