Faceplate lock switch
4Holding the center part of the faceplate, pull it out. The faceplate bracket will automatically close.
2CAUTION
•When removing the faceplate, pull it out only when it is fully open. The detachment of the faceplate while it is moving might result in damage to the unit.
•Do not apply excessive force to the faceplate bracket without attaching the faceplate. Doing so will cause the faceplate bracket to be deformed.
•Do not touch the connector on the faceplate bracket after removing the faceplate. Touching the connector may cause damage to the unit.
•Do not touch two metal parts on both sides of the faceplate bracket. Touching those parts may injure you.
NOTE
•Sliding the faceplate lock switch cause the unit’s power to turn off. If you want to operate the unit again, remove the faceplate from the faceplate bracket completely and then reattach it.
•The faceplate is a precision piece of equipment and can be damaged by shocks or jolts. For that reason, keep the faceplate in its special storage case while detached.
•Do not expose the faceplate or its storage case to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing.
Reattaching the Faceplate:
1Hold the faceplate so that the control panel faces the front toward you and set the left side of the faceplate in the faceplate bracket.
2CAUTION
Do not set the right side of the faceplate in the faceplate bracket first, when reattaching the faceplate. Doing so may cause the connector on the faceplate bracket to malfunction.
2Press the right side of the faceplate until it locks.
NOTE
If the faceplate bracket's angle was not set to the vertical when the faceplate was mounted, check that the faceplate is securely attached to the faceplate bracket by holding its right side and pulling it gently towards you.
— 15 —