Installation
Installation using the brackets
Tapping Screw 5
(Φ5 x 20 mm)
| Semusu Screw 4 |
Installation board, etc. | (M4 x 5 mm) |
| |
(thickness : 19 mm or more) | Bracket 3 |
|
Installation using the velcro tapes
Carpet
Velcro tape 6
¤
•Do not use your own screws. Use only the screws provided. If you use the wrong screws, you could damage the unit.
•Do not install the unit to an unstable place and a place where it vibrates.
•When making a hole under a seat, inside the trunk, or somewhere else in the vehicle, check that there is nothing hazardous on the opposite side such as a gasoline tank, brake pipe, or wiring harness, and be careful not to cause scratches or other damage.
•Do not install near the dashboard, rear tray, or air bag safety parts.
•The installation to the vehicle should securely fasten the unit to a place in which it will not obstruct driving. If the unit comes off due to a shock and hits a person or safety part, it may cause injury or an accident.
•After installing the unit, check to make sure that electrical equipment such as the brake lamps, turn signal lamps and windshield wipers operate normally.
•You can mount the unit at any angle between the regular horizontal position and the vertical position on its back (0° through 90°). You cannot mount the unit with the disc slot facing downwards, angled or upside down.
20