Troubleshooting Guide

What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems.

PROBLEMPOSSIBLE CAUSESOLUTION

 

 

 

The disc control mode cannot

No cable has been connected to the disc changer input

Connect the control cable to the disc changer input terminal

be selected.

terminal on the unit.

on the centre unit.

 

 

 

The disc cannot be changed.

Four MDs have been set in the main unit.

Remove the MD currently playing.

No sound can be heard, or the volume is low.

Attenuator is turned on.

Turn off Attenuator.

 

 

The fader or balance settings are set all the way to one

Reset the fader or balance settings.

side.

 

5 minutes have elapsed since the panel dropped open.

When 5 minutes have elapsed since the panel dropped open, the disc will automatically stop playing.

The spectrum analyser is not displayed.

The speaker input cable is not connected.

Refer to the "Connections" section, and connect the cable.

 

 

The fader setting has been adjusted to the rear side.

Adjust the fader control on the centre unit to the centre

 

position.

 

 

The analyser display level has been set too low.

Adjust it to a higher level.

 

 

The volume is too low.

Raise the volume, or alternatively, adjust the analyser display

 

level to a higher level.

Nothing happens when the

The computer chip in the unit is not functioning normally.

Press the reset button on the centre unit.

buttons are pressed.

 

 

 

 

 

The MD cannot be inserted.

There is already an MD loaded.

Eject the currently loaded MD and then load the new one.

 

 

 

The MD does not load.

The insertion orientation of the MD is incorrect or the MD

Insert the MD in the proper orientation.

 

is upside down.

 

 

 

 

The MD loads but soon comes

Nothing is recorded on the MD.

Switch the MD for one that is recorded.

out again.

 

 

 

 

 

A track will not play.

Random play has been selected.

Turn off random play.

The system will not enter the Menu mode.

The system is not in MD play mode.

If the main unit is not in MD play mode, it will not go into the Menu mode.

— 13 —