Installation
Installation of Controller
1According to the installation angle of the controller, install Spacer (Accessory 5) to Bracket (Accessory 6) as described below.
When installing on the
Accessory6
When installing on the
Accessory6
9
7
Accessory5
8 8 Accessory5
Accessory8
(Ø2 X 10, Black)
When installing on the
Accessory6
Accessory7
(Ø2 X 11.5, Blue)
Accessory9
(Ø2 X 9, White)
⁄
•The direct installation of Bracket (Accessory ⑥) without Spacer (Accessory 5) is also possible.
2From Spacer (Accessory 5), remove the chip in the direction where you want to wire the controller cable.
Accessory5
0 0
Accessory5
Accessory0
(Ø2 X 5, Black)
Chip
Break off the spacer chip in the direction where you want to wire the controller cable.
Drill a hole of 10 mm in diameter on the mounting surface when not using spacer or wiring the cable behind the mounting surface.
36