Installation Procedure

1.To prevent short circuits, remove the key from the ignition and disconnect the · terminal of the battery.

2.Make the proper input and output cable connections for each unit.

3.Connect the wiring harness connector to the unit.

4.Install the unit in your car.

5.Reconnect the · terminal of the battery.

6.Press the reset button. (page 3)

2WARNING

•To prevent shorting, disconnect the battery cable from the negative terminal of the battery during installation.

•Be sure to firmly stabilise this product. Do not install it in a location which is not stable.

•Follow the installation and wiring procedures described in this manual. Improper wiring or modified installation can not only result in malfunction or damage to the unit but may also result in an accident.

•Do not install the unit in the following locations.

•A location which interferes with the operation of the air bag system.

•A location which is not made of plastic.

\Installing on leather, wood or cloth may damage the surface.

•A location subject to direct sunlight, subject to the air from the air conditioner, or subject to moisture or high temperature.

\This may cause deformation of the monitor unit.

•If you are not going to install the unit using the supplied monitor stand, be sure to use a commercially available monitor stand. (Mounting holes for such a stand are located on the bottom of the monitor unit.)

¤

•If the fuse blows, first make sure that the wires have not caused a short circuit, then replace the old fuse with one with the same rating.

•Do not let unconnected wires or terminals touch metal on the car or anything else conducting electricity. To prevent short circuits do not remove the caps from unused terminals or from the ends of the unconnected wires.

•After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly.

•Insulate unconnected wires with vinyl tape or other similar material.

•Thoroughly wipe away oil and other dirt from the installation surface.

Please avoid installation on uneven surfaces.

English 7