Kenwood KPA-SD100 7

English-5

Installation

7Accessories

1Remote control light emitter (cable length:2.5m)...1 4Connection cable (2m)......................1

2Connection cable(ISO AB :0.1m).............................1 5Self-tapping screw (Ø4 X16mm)......4

3Connection cable(ISO C :2m)..................................1 6Adhesive double coated tape...........1

7Installing the Control Unit

•When drilling a hole below a seat or inside the trunk, check if there is the gas

tank, brake pipe, or wire harness behind the hole in advance. If so, be careful

not to damage them in any way.

•Do not install the Control Unit on the dashboard, on the rear tray, or near any

safety component such as an air bag.

•When installing the Control Unit on your vehicle, fasten it firmly to a part

where it does not disturb your smooth driving. Otherwise, if the Control Unit

comes off when excessively shocked, it may hit the driver or passenger or a

safety component, resulting in an injury or accident.

•When you have finished installing the Control Unit, make sure that electrical

parts such as the brake lights, turn signals, and windshield wipers work

normally.

7Installing the KPA-CP100 (Option)

1.Select the installation position slanting forward, backward, to

the left, or to the right at angle within 5 degrees, such as on the

dashboard.

2.Use the supplied adhesive double coated tape to fasten the

direction sensor firmly enough to remain fixed during driving,

with the up arrow facing right toward the front of the vehicle.

•The direction may not be displayed correctly at the following locations where magnetism is considerably disturbed. It is not an

error or failure.

(Under a land bridge or railway bridge, on a railroad crossing, under high-voltage power cables, near a broadcasting station,

power station, or substation, etc.)

•The direction may change as the windshield wiper swings. In this case, move the direction finder to a position where it is free

of the effect.

•When fastening the direction finder using the adhesive double coated tape, wipe dust, stains, oils, and water off the mounting

surface in advance, then stick it securely not to let it come off during driving.

•Since the direction finder uses terrestrial magnetism, it fails to display the correct direction unless it is installed at a level place

without a magnet or magnetic object around.

•Do not place the following objects near the installation position.

(Magnet, TV, radio antenna, speaker, metal, can, etc.)

7Connecting Units

Follow the precautions below before and when connecting units.

•Make sure first that the ignition switch does not have the key inserted. Then, be sure to disconnect the -terminal of the

battery to prevent a short-circuit from happening before connecting units.

•Plug each connector fully into the mating socket.

•Connect the connection cable to the Centre Unit.

•Up to three units can be connected to the centre unit. (This, however, does not include the KCA-S210A if it is connected to the

unit.)

•When connecting multiple units (such as the Stack CD Changer and

KPA-SS100 , 1998 model DAB), connect the KPA-SD100 directly to the

Centre Unit.

•The two units, KPA-SD100 and KPA-HD100, cannot be connected

together.

•The total length of the cable between the units should not be more than 13m.

•To add the KPA-CP100 to the system having both of the KPA-SD100 and KPA-SS100 installed, connect the KPA-CP100 to the

KPA-SS100.

•When you have finished connecting all the units, reset the Centre Unit once.

2CAUTION

CONTROL ADAPTER KPA-SD100

Audio board etc

Self-tapping

screw

(Ø4X16mm)5

Ø3

Direction

sensor

Front

Centre Unit KPA-SD100 KPA-SS100

Stack CD

changer

Not more than 13m