English
— 30—
Catch
Lock
Accessory2
Removal tool
— 30—
■Removing the hard rubber frame
2When the upper level is removed, remove the lower two
locations.
The frame can be removed from the bottom side in the same manner.
1Engage the catch pins on the removal tool and remove the
two locks on the upper level.
Upper the frame and pull it forward as shown in the figure.
■Removing the Unit
4Lower the removal tool
toward the bottom, and
pull out the unit halfway
while pressing towards the
inside.
5Pull the unit all the way out
with your hands, being
careful not to drop it.
Be careful to avoid injury from the catch pins on the removal tool.
1Refer to the section <Removing the hard rubber frame> and
then remove the hard rubber frame.
2Remove the screw (M4×8) on the back panel.
3Insert the two removal tools deeply into the slots on each
side, as shown.
Accessory2Removal tool
Screw (M4X8)
(commercially
available)
InstallationKRC-597(E)_U.S 03.10.7 6:48 PM Page 30