Kenwood KRC-6901R - page 37

— 37 —
The following messages are displayed when certain problems are occurring in your system. Take the recommended
actions.
Nothing has been recorded on the MD.
]The next MD is automatically played back
BLANK
No disc magazine has been loaded in the changer. The disc magazine is not completely loaded.
]Load the disc magazine properly.
No CD in the unit.
]Insert the CD.
EJECT
No tracks are recorded on the MD, although it has a title.
]The next MD is automatically played back.
NO TRACK
The unit is malfunctioning for some reason.
]Press the reset button on the unit. If the "E- 77", code does not disappear, consult your nearest service centre.
E-77
Something is wrong with the disc magazine. Or the unit is malfunctioning for some reason.
]Check the disc magazine. And then, press the reset button on the unit.
If the "E- 99" code does not disappear, consult your nearest service center.
E-99
The protective circuit in the unit activates when the temperature inside the automatic disc changer exceeds 60°C (140°F), stopping
all operation.
]Cool down the unit by opening the windows or turning on the air conditioner. As the temperature falls below 60°C (140°F), the
disc starts playing again.
HOLD
If this indicator continues blinking, it is possible that the tape has become jammed or tangled.
]Contact the Kenwood dealer if the tape cassette cannot be ejected.
¢
No disc has been loaded in the disc magazine.
]Load a disc into the disc magazine.
The CD is very dirty. The CD is upside-down. The CD is scratched a lot.
]Clean the CD and load it correctly.
E-04
No disc has been loaded in the disc magazine.
]Load a disc into the disc magazine.
NO DISC
The faceplate of the slave unit being connected to this unit has been removed.
]Replace it.
NO PANEL
KRC-6901R_U.K 2003.10.06 08:13 AM Page 37