Installation
■Installation for Hideaway unit
●Securing to audio board1Attach the installation brackets to the sidesof the hideaway unit using the sems bolts (M4 ⋅ 8 mm).Installation brackets (Accessory1)
Sems bolts
(M4 ⋅ 8 mm) (Accessory2)
2Use the tapping screw (ø4 ⋅ 16 mm) to secure the hideaway unit to the audio board.
Tapping screw
(ø4 ⋅ 16 mm) (Accessory3)
Peel the protective strips off of the velcro strips, attach them to the bottom of the hideaway unit, and secure to the pile carpet.
2CAUTION
Please do not install the unit near the dashboard, the rear tray, or other important components. Doing so could lead to injury or accident should the unit come off due to a shock and strike a person or an important component. Tapping screws should be used for mounting. (Attachment with velcro strips, although easy, can come off with a shock.)
Troubleshooting Guide
Velcro strips (Accessory4)
What might appear to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems.
PROBLEM | POSSIBLE CAUSE | SOLUTION |
|
|
|
The power does not turn on. | The fuse has blown. | After checking for short circuits in the |
|
| cables, replace the fuse with one |
|
| having the same rating. |
No sound can be heard, or the volume is low.
•The Attenuator function is turned on.
•The fader and/or balance settings are set all the way to one side.
•The input/output cables or wiring harness are connected incorrectly.
•Turn off the Attenuator function.
•Reset the fader and/or balance settings.
•Reconnect the input/output cables and/or the wiring harness correctly. See the section on "Connecting Cables to Terminals".
Nothing happens when the | The computer chip in the unit is not | Press the reset button on the unit |
buttons are pressed. | functioning normally. |
|
|
|
|