Connection
When handling an optical cable for wiring, use care not to exceed the minimum cable bend radius of 30 mm. If you exceed the minimum bend limit, optical fibers within the optical cable may be damaged.
30R
An Optical cable (Accessory 3) is fixed with a chassis using harness band (Accessory ^).
For the sake of safety, be sure to connect the parking sensor.
Connect to the vehicle's parking brake detection switch harness using the supplied relay connector.
| Optical output | Monitor unit |
| (Black) | Accessory 4 |
|
PRK SW
| To vehicle's reverse lamp harness | |
| To car light control switch | |
|
| To Steering remote |
Car fuse box | Ignition key switch | A |
(Main fuse) | ACC | |
REVERSE
Dimmer control wire (Orange/White)ILLUMI
Steering remote control input (Light Blue/Yellow)REMO.CONT
Ignition wire (Red)ACC
A |
B |
| B |
| Car fuse box | C |
C
BATT
Ground wire (Black)Receiver unit (front side)
+ |
|
|
|
|
|
|
|
|
|
|
|
| AV OUTPUT |
|
| PRE OUTPUT | |
|
|
|
|
|
| REAR | FRONT | |
|
| AV INPUT 2 |
|
|
|
| ||
| Battery | VIDEO | L | R | L | CENTER | L | L | |
| FM/AM antenna input FM /AM ANTENNA | AV INPUT 1 |
|
| VIDEO | SUB |
| POWER | |
| VIDEO | L | R | R | [MONO] | R | R | |
| Antenna Cord | Accessory 5 |
|
|
|
|
|
|
|
Accessory %
C
B
Accessory 1 
Ground wire (Black)
Battery wire (Yellow) | (10A) |
Connect to the terminal that is grounded when either the Mute wire (Brown) telephone rings or during conversation.
MUTE
To connect the Kenwood navigation system, consult your navigation manual.
Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the
When using the optional power amplifier, connect to its power control terminal.
ANT CONT
Power control wire (Blue/White)P. CONT
To "EXT.AMP.CONT." terminal of the amplifier having the external amp control function.
EXT.CONT