Accesaries/Installation Procedure
Accessories
①
DC Cord .......... | 1 |
②
Monitor Cable .......... | 2 |
Installation Procedure
1.To prevent short circuits, remove the key from the
ignition and disconnect the 
terminal of the battery.
2.Make the proper input and output cable connections for each unit.
3.Connect the wiring harness wires in the following order: ground, ignition.
4.Connect the wiring harness connector to the unit.
5.Install the unit in your car.
6.Reconnect the 
terminal of the battery.
7.Press the reset button. (page 2)
③
④
⑤
⑥
⑦
⑧
RCA Cable .......... | 2 |
| Remote Control Cable .......... | 1 |
612IRREMOVAL TOOL GUIDE |
| |
| Template .......... | 1 |
LZ- |
|
|
Mounting Bracket .......... | 2 |
Removal Tool .......... | 1 |
Mounting Screw (Ø4x16) .......... | 2 |
WARNING
•This product is intended for use with 12V DC negative ground power only. Do not connect it to any other power supply.
•To prevent shorting, disconnect the battery cable from the negative terminal of the battery during installation.
•Be sure to firmly stabilise this product. Do not install it in a location which is not stable.
•Follow the installation and wiring procedures described in this manual. Improper wiring or modified installation can not only result in malfunction or damage to the unit but may also result in an accident.
•Mounting and wiring this product requires skills and experience. For safety's sake, leave the mounting and wiring work to professionals.
•If your car’s ignition does not come with an ACC position, connect the ignition wires to a power source that can be turned on and off with the ignition key. If you connect the ignition wire to a power source that receives a constant voltage supply, as with battery wires, the battery may die.
•If the fuse blows, first make sure that the wires have not caused a short circuit, then replace the old fuse with one with the same rating.
•Do not let unconnected wires or terminals touch metal on the car or anything else conducting electricity. To prevent short circuits do not remove the caps from unused terminals or from the ends of the unconnected wires.
•After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly.
•Insulate unconnected wires with vinyl tape or other similar material.
•Thoroughly wipe away oil and other dirt from the installation surface.
Please avoid installation on uneven surfaces.
•Do not install the Hideaway Unit under the carpet.
Otherwise heat
8