English
12
Installation

Installation for Monitor Unit

Installation location and cleaning

Select for installation a location where the stand can be
placed completely horizontal or where the front edge of the
support (petal-shaped part) can be attached horizontally as
shown in Figure A.
Do not install in locations where the entire support is at a
diagonal such as in Figure Bor where the monitor unit is
facing down such as in Figure C.
Thoroughly wipe away and dust or grease from the
installation location using a cloth which has been soaked in
a neutral cleaning agent and wrung out. Attach the stand
after allowing the installation location to dry.
ABC
Bend the stand support to conform to the shape of
the installation location.
Adjust the shape of the support so that there is no
rattling or gap when the stand is placed on the
support.
Peel off the protective strip from the double-sided
tape on the bottom of the stand and securely attach
the stand.
•Do not attach the double-sided tape more than once
or touch the adhesive with your fingers as this will
weaken its adhesive strength.
•If the temperature of the surface of the installation
location is low, warm it up using a heater or other
means before attaching the stand. Low
temperature may weaken the adhesive strength of
the tape.
•The supplied stand is specially intended for this
product. Do not use it with another television.
Secure the stand using the supplied tapping screw
(Accessory 4).
After attaching the stand, allow it to sit undisturbed
for 24 hours.
Take care not to apply any force to the stand during
this time.
Fully loosen the installation screws, align the slit on
the rear of the unit with the installation shoe and slide
the monitor unit onto the stand.
Adjust the height, horizontal angle and vertical angle
of the monitor and securely tighten the installation
screws.
You can also adjust the monitor unit's forward
position by loosening the angle adjustment knobs and
adjusting the angle of the monitor unit's installation
stand.

8

7

6

5

4
2CAUTION
3
2
1
Accessory3
Accessory 4
(Ø4 x 12 mm)
Protective strip
Loosen
Tighten
Tighten
Loosen
Installation surface
LZ_800W_English_ver4 02.12.16 1:17 PM Page 12