Installation
Accessories
2 | - | 1 - Monitor Bracket |
| (KMSI832) | (KMB701) |
2 | - | 2 - |
| Black Machine Screw | (KSN1420) |
(KMSB832.5)
Remove Factory Console
Open the console lid and remove the (2) |
|
screws toward the rear of the console. Fold |
|
down the cup holder on the rear of the console |
|
until it hits the stops. Continue to push down |
|
on the cup holder snapping it past the stops. |
|
Remove the (2) screws inside the cup holder |
|
recess. Unsnap the rear portion of the console |
|
and disconnect wiring. The rear radio controls |
|
(if equipped) will be relocated to the | Factory Console |
console. |
|
The power point can be relocated to the |
|
optional factory mounting location inside the |
|
console storage bin if so desired.(see picture at |
|
right) |
|
NOTE: If installing into truck with console | Optional Power Port Location |
mounted air vents follow these instructions. |
|
Remove the remaining five screws around the top edge of the console storage bin. Remove the four 10mm bolts in the bottom of the storage bin. Gently lift up and remove the bin. Pull out and remove the
Prepare Video Console
Radio Control Unit
Fit the previously removed rear radio control box into the video console. If the vehicle was not equipped with rear radio controls, fit the supplied
#8 x 1/2” sheet metal screws through the predrilled holes into the plastic housing.
Wiring and Connections
Route all wires and cables at this time. Install wiring and cables according to the instruction provided with electronic equipment. Run all cable for external video sources at this time.
Installation of Video Console
Prepare the monitor for installation by sliding the small studded bracket into the back panel of the monitor. Run the monitor data cable through the
Slide the metal bracket on the video console into place between the storage bin and the console and snap into place(Make sure that no cables are pinched). Make a mark on the console using the
inserts into the oblong hole on each side of the console, at the mark previously made.)
Final Steps
Turn on and test everything.
(If system does not work properly, recheck all connections and fuses).
The installation of your new Video
System is now complete.
Rev |