Kenwood TKR-850, TRK-750 instruction manual

INSTALLATION

To install the handles onto the front panel of the repeater,

align the handles with the holes on the front panel, then

secure the handles using the supplied screws.

Please consult your dealer for installing the repeater and

antenna.

MICROPHONE

Connect an optional KMC-30 (E type only), KMC-27A,

KMC-27B, or KMC-9C KENWOOD microphone to the

MIC jack on the front panel.

VHF FM REPEATER/ UHF FM REPEATER

TKR-750/ TKR-850

INSTRUCTION MANUAL

KENWOOD CORPORATION

09 08 07 06 05 04 03 02

NOTICES TO THE USER

UNPACKING AND CHECKING EQUIPMENT

Note:

The following unpacking information is for use by your

KENWOOD

dealer, an authorized

KENWOOD

service facility, or the factory.

Carefully unpack the repeater. We recommend that you

identify the items listed in the following table before

discarding the packing material. If any items are missing

or have been damaged during shipment, file a claim with

the carrier immediately.

FCC WARNING

This equipment generates or uses radio frequency energy. Changes or

modifications to this equipment may cause harmful interference unless

the modifications are expressly approved in the instruction manual. The

user could lose the authority to operate this equipment if an unauthorized

change or modification is made.

◆

GOVERNMENT LAW PROHIBITS THE OPERATION OF

UNLICENSED RADIO TRANSMITTERS WITHIN THE

TERRITORIES UNDER GOVERNMENT CONTROL.

◆

ILLEGAL OPERATION IS PUNISHABLE BY FINE OR

IMPRISONMENT OR BOTH.

◆

REFER SERVICE TO QUALIFIED TECHNICIANS ONLY.

metI rebmuNtraP ytitnauQ

erutxiferawdraH4X-2048-12J1

ssalgtnorF4X-5362-01B1

retliF4X-9521-11B1

noihsuC4X-1081-31G4

noihsuC4X-2081-31G4

tooF5X-5740-20J2

tooF4X-2940-20J2

temmorG5X-2030-95J2

eldnaH5X-8140-10K1

swercS54-6003-53N5

drocCD5X-7243-03E1

elbacrotcennoC5X-8223-13E1

esuF5X-7351-50F1

)ylnoepytK(dracytnarraW—1

launamnoitcurtsnIXX-7231-26B1

THANK YOU!

We are grateful you purchased this KENWOOD repeater.

We believe this easy-to-program repeater will be highly

effective in your communications system, and will keep

personnel operating at peak efficiency.

KENWOOD incorporates the latest in advanced technol-

ogy into all of our products. As a result, we feel strongly

that you will be pleased with the quality and features of

this product.

FEATURES

•You can easily program channel data using the KPG-66D

software on a PC.

•You can recall 1 of 16 preset channels using either a PF key

or the external control line.

•The firmware can be written to the Flash memory through

an external source.

•QT/DQT signalling can be programmed on each channel. It

simultaneously decodes up to 16 different QT/DQT tones.

•The interface port can be used with external equipment,

such as a repeater controller.

•The repeater has multi-mode capability.

Wide: 30 kHz/ Narrow:15 kHz (TKR-750; K type only)

Wide: 25 kHz/ Narrow:12.5 kHz (TKR-750/ TKR-850)

•You can adjust the following functions from a PC:

•Squelch

•RX audio signal output (RA)

•RX detector signal output (RD)

•RX frequency

•RF output power

•Maximum deviation

•TX audio input (TA)

•Signalling deviation (TD)

•DQT balance

•QT deviation

•DQT deviation

•Test tone deviation

•CW ID deviation

•Repeat gain

•TX frequency

PRECAUTIONS

•Do not expose the unit to rain or moisture; to prevent fire or

electric shock.

•Do not open the unit under any circumstances; to avoid risk

of electric shock.

•Do not expose the unit to long periods of direct sunlight, nor

place it close to heating appliances.

•Do not place the unit in excessively dusty and/or humid

areas, nor on unstable surfaces.

•If you detect an abnormal odor or smoke coming from the

unit, disconnect the power from the unit immediately.

Contact your KENWOOD service center or dealer.