60
13 MEMORY FEATURES
■Memory Scroll
1Press [M.IN] to enter Memory Scroll mode.
•The memory channel that was last selected
appears.
2Turn the MULTI/ CH control, or press Mic [UP]/
[DWN] to step through the memory channels.
• You can also change channels by entering a
3-digit number, such as 012, using the
numeric keys, then pressing [ENT].
3To exit Memory Scroll mode, press [CLR].
• The transceiver re-displays the memory
channel or VFO frequency that was
selected before you activated Memory
Scroll.
Note: Do not press [M.IN] again after entering Memory Scroll
mode. Pressing [M.IN] results in over-writing the current VFO
data to the memory channel you selected.
■Temporary Frequency Changes
After retrieving frequencies and associated data in
Memory Recall mode, you can temporarily change
the data without overwriting the contents of the
memory channel.
1Access Menu No. 06B and select ON.
• Skip this step when changing only the
associated data (not the frequency).
2Recall a memory channel.
3Change the frequencies and associated data.
• Use only the Tuning control to select a
frequency.
4If necessary for future use, store the changed
data in another memory channel. Refer to
“Channel ➡ Channel Transfer” {page 61}.
Note: Memory channel data can also be changed while using
the TF-SET function.
MEMORY-VFO SPLIT OPERATION
Under “ENHANCED COMMUNICATIONS” {page31},
you learned about split-frequency operation using two
VFOs. Recalling a split-frequency channel is another
way to perform split-frequency operation. If you
access Menu No. 06A and select ON, you can also
use a memory channel and a VFO together for this
operation, as follows:
• RX: Memory channel
TX: VFO A or VFO B
• RX: VFO A or VFO B
TX: Memory channel
To use a memory channel for receiving:
1Access Menu No. 06A and select ON.
2Press [A/B] to select the VFO that you will use for
transmitting.
•“tA” or “tB” appears to show which VFO is
selected.
3Select the frequency for transmitting.
4Recall a memory channel by pressing [VFO/M].
5Turn the MULTI/ CH control to select a memory
channel to receive.
6Press [SPLIT].
7The VFO A frequency appears on the sub-display.
If you want to use the VFO B frequency to
transmit, press [SPLIT] again.
8Press [SEND] or Mic [PTT] to transmit on the
frequency shown on the sub display.
9Press [SPLIT] to exit the SPLIT operation.
• If Split operation is still selected using VFO A or
VFO B, press [SPLIT] again to exit Split
operation.
To use a memory channel for transmitting:
1Access Menu No. 06A and select ON.
2Recall a memory channel by pressing [VFO/M].
3Turn the MULTI/ CH control to select a memory
channel to transmit.
4Press [VFO/M] to return to VFO mode.
5Press [SPLIT]. The other VFO frequency appears
on the sub display for transmission (Normal SPLIT
operation).
6Press [SPLIT] again. The memory channel you
selected in step 3 appears on the sub-display for
transmission.
7Press [SEND] or Mic [PTT] to transmit on the
frequency in the memory channel.
8Press [SPLIT] to exit SPLIT operation.