Keurig B150 manual Maintenance, Purpose

Maintenance

Purpose

This section describes the Maintenance Mode and key sequences for entry into this mode for the B150 Brewer.

Maintenance Mode Layout

Entry: From STANDBY, press all 4 corners of the touchscreen (Upper Left/Right and Lower Left/Right in any order) within 3 seconds, – releasing after each touch

1.	Screen 1	– “Software Version”	(e.g. “ v8.25”)
2.	Screen 2	– “Total Brew Count”	(Max = 999,999 [25 x
	Life])	– “Postfill Timeouts”	(Max = 65535)
		– “Add2 Timeouts”	(Max = 65535)
3.	Screen 3	– “Add4 Timeouts”	(Max = 65535)
		– “Add6 Timeouts”	(Max = 65535)
		– “Add8 Timeouts”	(Max = 65535)
4.	Screen 4	– “Dispense Timeouts”	(Max = 65535)
		– “Over-Pressure Events”	(Max = 65535)
		– “Top of Tank Events”	(Max = 65535)
5.	Screen 5	– “Run Hours”	(Max = 999,999 [114
	years])	– “4 oz Brew Count”	(Max = 65535)
		– “6 oz Brew Count”	(Max = 65535)
6.	Screen 6	– “8 oz Brew Count”	(Max = 65535)
		– “10 oz Brew Count”	(Max = 65535)
		– “12 oz Brew Count”	(Max = 65535)

7.Screen 7 – (Buttons control Opening/Closing the Valve) Brew Button = Cont.

8.Screen 8 – (Buttons control Turning Pump On/Off) Brew Button = Cont.

9.Screen 9 – “Brew Pump”

“Vent Valves”

(Buttons control Brew Pump On/Off & Opening/Closing the Valve)

10.Screen 10 – Touchscreen Calibration

–Press Brew button to exit OR touch display to start calibration.

–IF Cal Passes, exit. If it fails, give another opportunity to try

11.– Exit back to the Standby State

NOTE:

•Progress from screen to screen using the flashing Brew Button

9