Keurig B31 manual Cleaning the Cold Water Reservoir, Emptying the Internal Hot Water Tank, Storage

Section 5 Cleaning & Maintenance (continued)

Cleaning the Cold Water Reservoir

To access the Cold Water Reservoir, lift the Cold Water Reservoir Lid. Remove the Water Level Guide (fig. 5), then clean the inside of the reservoir with a damp, lint-free cloth as necessary (fig. 6). Replace the Water Level Guide and close the Cold Water Reservoir Lid when finished. NOTE: The Water

Level Guide is not dishwasher safe.

fig. 5 fig. 6

Emptying the Internal Hot Water Tank

1.Brewer must be powered off and plugged in.

2.Ensure that the Cold Water Reservoir Lid is closed.

3.Place a mug on the Drip Tray, then press and hold the BREW Button until all the water has been dispensed. NOTE: There will be a delay of 3– 4 seconds before water begins to dispense.

Storage

Empty the Internal Hot Water Tank and Cold Water Reservoir before storing. Ensure that you store your Brewer in a safe and frost-free environment, and in an upright position. Storing the Brewer in cold temperatures may cause condensation to freeze inside the Brewer and cause damage.

Before using your Brewer after storage, wipe the Cold Water Reservoir with a damp, lint-free cloth and run three cleansing brews without a K-Cup®portion pack. See page 8 for more information.

If your Brewer has been in an environment below freezing, allow the Brewer to rest at room temperature for at least 2 hours before powering on.

Storing the Power Cord

Behind the Brewer is a convenient compartment that will hold the

Power Cord (fig. 7). This makes the Brewer both easier to store and easier to take on the go.

fig. 7

14