Kicker 10ZXM3504 manual Model External Fuse Power/Ground Wire, Protection LED

Crimp and solder RCA connectors to the end of the speaker wire running from the high-level speaker outputs on the source unit and connect the wire to the RCA Inputs on the end panel of the amplifi er or simplify the installation by using a KICKER ZISL as shown below. Keep the audio signal cable away from factory wiring harnesses and other power wiring. If you need to cross this wiring, cross it at a 90 degree angle.

source unit	core conductor	to amplifi er	KICKER ZISL
high-level speaker
outputs

OR

+ –

shield

to amplifi er

source unit high-level speaker outputs

Install a fuse within 18” (45cm) of the battery and in-line with the power cable connected to your amplifi er. If you ever need to remove the amplifi er from the vehicle after it has been installed, the ground wire should be the last wire disconnected from the amplifi er--just the opposite as when you installed it.

Model	External Fuse	Power/Ground Wire
ZXM350.4	1 x 40 Ampere	8 Gauge

GND REM +12V protection LED

		≤18”
		(45cm)
remote turn-on	external fuse	12V
(see page 5)		battery

2010 ZXM 350.4 RevD.indd 3

3

1/15/2010 11:17:47 AM