TCVented
The TC Series vented enclosure combines KICKER’s award winning line of subwoofers with computer- modeled and human
The Kicker TC Series enclosure is designed to fit behind the seat of a pickup truck, coupe or wherever space is limited. This design is engineered to provide the best bass response when firing into the back of the seat. The vent opening in this enclosure can not be obstructed. At some frequencies most of the bass will come out of the vent. Therefore we recommend you leave at least four inches (10cm) of clear space around the vent.
| Plug your subwoofer speaker wire into the terminals, using the red connector as positive and the black | |
INSTALLATION | connector as negative. Hook the other end of the wire to your subwoofer amplifier in accordance with | |
Door | Kicker ZX line of | |
| its owner's manual. | Pro Tip: You are one ZX Mono- |
|
| Amplifier and a few cables away |
|
| from a slamm’in system! The |
| Frame | make it easy to upgrade to rock- |
|
| solid bass with your existing or |
stock source unit. Please ask your dealer about the Kicker ZX Amplifier upgrades.
Seat
Behind the seat
mounting, speaker fires into the back of the seat
(TC Series is
illustrated)
Figure 4
| Mount Brackets to the bottom of the enclosure |
| ||||
| using the supplied smaller screws. Securely |
| ||||
| attach the enclosure to the vehicle with the |
| ||||
| supplied larger screws. (VC Series is illustrated) |
| ||||
Comp Subwoofer - Covered by one or more of the following patents: |
| |||||
U.S. Pat #'s 6,611,604, 6,731,773 D473,216, D456,386, D449,293, |
| |||||
D355,193, Taiwan Pat. #162,154; Other U.S. and foreign patents pending. |
| |||||
Performance |
|
|
|
|
| |
Model: | DC10 | DC12 |
| |||
|
|
|
| |||
Nominal Impedance [Zn], ohm [per enclosure] | 2 or 4 | 2 or 4 |
| |||
Sensitivity [SPLo], dB @ 1W, 1m | 98.4 | 99.9 | PERFORMANCE | |||
Power Handling Watts, Peak (RMS) | 600 (300) | 600 (300) | ||||
Enclosure Top Surface Depth, in (cm) | 13 | 7/16 (34.1) | 13 | 15/16 (35.4) | ||
Enclosure Bottom Surface Depth, in (cm) | 16 | 7/16 (41.8) | 17 | 3/8 (44.1) | ||
Enclosure Height, in (cm) | 14 | (35.6) | 16 | (40.6) | ||
Enclosure Width, in (cm) | 28 | 1/2 (72.4) | 32 | 1/2 (82.6) | ||
| ||||||
Model: | VC12 | TC10 |
| |||
|
|
|
|
|
| |
Nominal Impedance [Zn], ohm [per enclosure] | 4 |
| 4 |
|
| |
Floor Board
SafetyWarning
Figure 3
Sensitivity [SPLo], dB @ 1W, 1m | 95.3 | 93.8 | ||
Power Handling Watts, Peak (RMS) | 300 (150) | 300 (150) | ||
Enclosure Top Surface Depth, in (cm) | 11 | 9/16 (29.4) | 4 | (10.2) |
Enclosure Bottom Surface Depth, in (cm) | 14 | 13/16 (37.6) | 7 | 5/8 (19.4) |
To avoid potential injury, or possible death, from forward movement of the enclosure during abrupt stops or accidents, the enclosure must be properly installed and securely fastened to your vehicle. You are solely responsible for securely fastening the enclosure in your vehicle.
4 | COMPSUBWOOFERENCLOSURE |
Enclosure Height, in (cm) | 16 | (40.6) | 15 | (38.1) |
Enclosure Width, in (cm) | 17 | 1/2 (44.5) | 21 | 1/2 (54.6) |
Note: The use of a subsonic filter will significantly increase the power handling. The power handling specifications in these charts are |
|
calculated using a 25Hz, 24dB per octave subsonic filter. Measurements based on 4 ohm voice coil models. All specifications and | 5 |
performance figures are subject to change. Please visit the www.kicker.com for the most current information. |
