![](/images/new-backgrounds/1000455/4557x1.webp)
Features
End Panel Views
The BLAST Port is used to connect the Remote Bass Level Controller and for transferring control signals from one SX amplifier to another SX amplifier. An RJ45 cable is required to connect the BLAST Port (Out) of one amp to the BLAST Port (In) of another. This is only required if you want to control more than one amplifier with the same Bass Level Controller. More details on this further in the manual.
The speaker terminals are
Power LED indicates amplifier is powered up and operating.
Check Fuse LED indicates a fault with the end panel fuses. This could be fuses which are not seated properly, faulty fuses or blown fuses.
BLAST Port In | BLAST Port Out |
Left + | Right - | |
Left - | Right + | |
Right + | Left - | |
Right - | Left + | |
| Left PAST | |
| Amp 2 Left Input | |
| Amp 1 Left Input | |
|
|
|
Amp 1 Right Input
Amp 2 Right Input
Right PAST
Power LED
Check Fuse LED
Fusing
XX | XX |
Ground
Remote
+ 12 Volt
Mounting
When selecting a location to mount your Kicker amplifier be sure it is structurally sound and that there are no items behind the area that could be damaged by the screws. Check for wiring, brake lines, fuel lines, gas tanks, etc.
All amplifiers generate heat under normal operation. Be sure to choose a location that allows adequate ventilation for the amplifier. Also consider that the air temperature inside an automobile’s trunk can reach upwards of 140 degrees fahren- heit. An amplifier mounted in the trunk may require additional cooling such as extra fans moving air around the amplifier’s chassis or ventilating the trunk to exchange the hot air in the trunk for cooler air outside. If possible, mounting the amp in the passenger compartment will allow cooler operation.
Remember that the controls on top of the amp will need to be accessible for adjustment later. Keep this in mind as you choose your amplifier’s mounting location.
Now that you are ready to mount your amplifier, use the supplied 3mm allen wrench to remove the amplifier EndKaps. This will give you access to the mounting holes in the amplifi- er and all wiring connections.
See Fig. 1
Remove | Remove |
AMP1 AMP2
LOCK LEFT SYS RIGHT MUTE
GAIN EQ LPF HPF PHASE KOMP
* kicker *
M1 M2 M3 M4
ESC HOME ENT
Remove | Fig. 1 | Remove |
With the EndKaps removed, you now have access to the four mounting holes in the mounting feet and all wiring connections. Drill 4 holes using a 7/64” drill bit and use the supplied #8 screws to mount the amplifier.
See Fig. 2
AMP 1 | AMP 2 |
LOCK | LEFT SYS RIGHT MUTE |
GAINEQ LPF HPF PHASE KOMP
8.8.8.8.8.8.8.8.8.8
M1 M2 M3 M4
ESC HOME ENT
Fig. 2
Installation
6 | SX .4 Series Amplifiers |
SX .4 Series Amplifiers | 7 |