Kidde RF-SND manual Trouble Shooting Guide, Problem, Possible cause, Solution

8. TROUBLE SHOOTING GUIDE

Problem	Possible cause	Solution
Not all of the	Devices may not all	Locate the 8-position dipswitch on the back of each
alarms/accessories	be on the same ID.	unit and ensure that all of the corresponding switches
produce an alarm		are set the same. If an ID needs to be changed:
signal when the Test		Remove power, change the ID and reapply power.
button is pushed on
a unit.	Devices may not have	Check to see if the Green LED is on continuously (this
	power.	tells you the alarm is receiving AC power) or that it
		blinks every ten seconds (this tells you that it is receiving
		only battery power). If not make sure the batteries are
		installed correctly and the AC outlet has power. If the
		alarm is not receiving AC power but is receiving battery
		(DC) power the green LED will flash every 10 seconds.
		Contact a qualified electrician to check power to the
		wires.
	Button not pressed	Press and hold the button for a minimum of 5 seconds
	long enough.
	There may be too	Move the other units to a new location and try again..
	much interference	You should try to locate the Wireless units as closely to
	between units.	each other as possible.
Units signal an	Unit is set to the	Change the ID of your units by following the instruc-
alarm when no fire	same ID as a system	tions in section 3. INSTALLATION INSTRUCTIONS, WIRE-
is present and none	nearby.	LESS INTERCONNECT SETUP. Make sure to power all the
of the test buttons		units off before changing the switch positions.
have been pushed.
	Unit is located in area	Review section 2.LOCATIONS TO AVOID. Relocate the
	prone to cause false	unit.
	alarms.
	Wireless Interference.	Move the other units to a new location.