device installed and interconnected in each separate sleeping area, and visual notification equipment interconnected with heat, smoke, or CO alarms in the living rooms, dining rooms, kitchens, hallways, attics, furnace rooms, closets, utility storage rooms, basements, and attached garages.
6. TESTING AND OPERATION
WARNING! THIS STROBE LIGHT IS EXTREMELY BRIGHT. DO NOT LOOK DIRECTLY AT THE LIGHT OR TOUCH THE LENS WHEN THE LIGHT IS FLASHING.
TESTING: Test by pushing the test button on one of the controlling alarms and hold it down for a minimum of 5 seconds after the alarms sounds. This will allow the controlling device to sound an alarm if all the electronics, circuitry, and horn are working. The controlling alarm will also send an activation signal through the interconnecting wiring to the strobe light, and cause the strobe light to flash if strobe light and the interconnection wiring are working properly.
If no alarm sounds check the fuse or circuit breaker supplying power to the alarm circuit.
If the alarm sounds but the strobe light does not activate, refer to section 5 to insure that the strobe light is wired properly.
TEST THE STROBE LIGHT AND YOUR ALARMS WEEKLY TO ENSURE PROPER OPERATION.
OPERATION: The strobe light is operating once AC power is applied, and testing is complete. When the strobe light is activated, it will flash for as long as the controlling alarm remains active.
7. MAINTENANCE
STROBE LIGHT REMOVAL:
IF TAMPER RESIST PIN HAS BEEN USED, REFER TO “TAMPER RESIST LOCKING PIN” IN SECTION (5) FOR PIN REMOVAL INSTRUCTIONS.
CLEANING YOUR STROBE LIGHT:
To clean your Strobe light remove it from the mounting bracket and disconnect the AC Quick Connect power harness as outlined in section 5.
You can clean dust from your strobe light by using a vacuum cleaner hose and vacuuming around the cover and lens openings on the strobe light.
The outside of the strobe light can be wiped with a damp cloth.