Pull the AC QUICK CONNECTOR through the center hole in the ring and mount the ring, making sure that the mounting screws are positioned in the small ends of the keyholes before tightening the screws (see fig. 3).

Plug the AC QUICK CONNECTOR into the back of the strobe light, (see fig. 4) making sure that the locks on the connector snap into place.

To remove AC

Alignment Marks

connector,

 

squeeze

Tamper resistant

locking

locking pin

arm and

 

pull.

 

Install

 

Remove

FIGURE 4

FIGURE 5

FIGURE 6

If you have finished all the WIRING AND TRIM RING MOUNTING STEPS, you can install the strobe light on the trim ring. Alignment marks are provided on the side of the strobe light and on the Install the strobe light on the trim ring with the indicating marks aligned and rotate the detector in the direction of the ON arrow on the cover until the strobe light snaps in place. (See fig. 5)

Turn on the AC power, The model SL177i strobe light has a green AC power on indicator which should be lit when the strobe is operating from AC power.

TAMPER RESIST LOCKING PIN: To make your strobe light tamper resistant a locking pin has been provided with your strobe light. Using this pin will help deter individuals from removing the strobe light from the trim ring. To use the pin insert it into the hole in the side of the strobe light after the strobe light has been installed on the trim ring (see fig. 6). NOTE: The tamper resist pin will have to be removed in order to remove the strobe light. This can be done easily with a long nose pliers. Using the long nose pliers, pull the pin out of the hole, it is now possible to remove the strobe light from the trim ring.

After installation TEST your strobe light by following the test procedure outlined in section 6.

CAUTION! Early warning fire detection and visual notification is best achieved by the installation of fire detection and visual notification equipment in all rooms and areas of the household as follows: A smoke alarm and visual notification