ELECTRICAL HAZARD WARNING!
Page 12
INTERNAL WIRING (Fig. 10)
1. Connect the 50’ coax cable from “MAIN” on dome unit to the tuner port labeled “ANT.”
2. Connect the 7’ coax from the tuner port labeled “REC” to the main satellite receiver port
labeled “SATELLITE IN.”
3. Connect the 7’ controller cable from the controller to the tuner port labeled “IDD.”
4. If installing a second receiver, connect the 50’ coax cable from “AUX” on dome unit to the
“SATELLITE IN” port on the second receiver.
5. Connect the power supply cable to the tuner port labeled “PWR”.
6. Plug the power supply into a 110 VAC source.
Note: The controller should turn on for 3 seconds and then turn off. If the controller stays on,
press the ENTER and “-” button simultaneously for 3 seconds to turn unit off.
The coaxial cable that connects the dome unit to the tuner
carries a 24 volt electrical current. Exercise extreme
caution when handling this cable. Do not cut, break, or
splice this line. Do not insert or connect any devices such
as splitters or any other device for any reason. This line is
not compatible with any other equipment. Damage will
occur to any device other than the dome unit if connected
to the antenna port on the tuner.
IMPORTANT! The 50’coax from the “MAIN” port on the dome unit MUST be connected
to the Tuner (IDB) in the vessel.
Coax connections should be snug. DO NOT OVER TIGHTEN!
Note. Apply non-conductive electrolytic grease to all stingers before installation.
Note: Make sure the proper connections are made between the receivers and TVs.
IMPORTANT! When connecting the power supply cable to the tuner, push in the power
supply cable end until it is flush against the back of the tuner.