BLENDER SERVICE MANUAL
Blender Assembly
1.Put locking collar with blades pointing up on a sturdy surface (Fig. 2).
Figure 2
2.Put sealing ring (1), flat side down, around the blades and into the groove within the locking collar (2) (Fig. 3).
1
2
Figure 3
3.Align the pitcher tabs with the slots of the locking collar (Fig. 4).
Figure 4
4.Press down and rotate pitcher clockwise, approximately ¼ turn until two clicks are heard (Fig. 5).
Figure 5
5. Adjust the length of the blender power cord (Fig.6).
Figure 6
6. Put pitcher assembly onto the blender base (Fig. 7).
Figure 7
NOTE: When properly positioned, pitcher assembly will rest completely on blender base. If not, repeat steps 3 and 4.
7. Put lid on pitcher.
WARNING
Electrical Shock Hazard
Plug into grounded outlet. Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire or electrical shock.
8.Plug power cord into a grounded outlet. Blender is now ready for operation.
9.Before removing the pitcher assembly from the base, always press “O” and unplug the power cord.
5
