5
Front View for Side by Side Models
NOTE: Width dimensions shown represent distance from outside
trim to outside trim.
Width of Refrigerator:
Front View for Bottom Mount Models
NOTE: Width dimensions shown represent distance from outside
trim to outside trim.
Opening Dimensions
The built-in refrigerator can be installed into a recessed opening
in the cabinets or at the end of cabinets using a side panel to
enclose the refrigerator side.
NOTE: Installation requires a ¹⁄₂ in. (12.7 mm) clearance to
remove the top grille and for proper airflow.
1. A
¹⁄₂
in. (12.7 mm) space is required
Location Preparation:
1. Wall studs must be located on rear wall 80 in. to 90 in.
(203 - 229 cm) above floor.
NOTE: The solid soffit must be within 1 in. (2.5 cm) maximum
above the refrigerator. If the solid soffit is higher than
1i n. (2.5 cm) or one is not available, then the refrigerator
must be braced to prevent tipping during use. See the “Install
Anti-Tip Boards” section.
2. Grounded electrical outlet should be placed in the top
shaded area, 4 in. (10.2 cm) from the right side of the
cabinets or end panel (see the “Electrical Requirements”
section).
Model Width A (as shown above)
36 in. (91 cm)
42 in. (106 cm)
48 in. (122 cm)
36¹⁄₄ in. (92 cm)
42¹⁄₄ in. (107 cm)
48¹⁄₄ in. (123 cm)
831
/
8"
(211 cm)
A
(see chart following)
36
1
/
4
" (92 cm)
83
1
/
8
"
(211 cm)*
1