5
INSTALLATION REQUIREMENTS

Tools and Parts

Style 1 - Freestanding Outdoor Grills

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
Parts Supplied
■Gas pressure regulator/hose assembly set for 11" WCP LP
gas (attached to manifold).
■1.5-volt “D” size alkaline battery
Parts Needed
■20 lb LP gas fuel tank

Tools and Parts

Style 2 - Built-In Outdoor Grills

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
Parts Needed
■Gas line shutoff valve
■½" male pipe thread nipple for connection to pressure
regulator.
■LP gas-resistant pipe-joint compound
■CSA design-certified outdoor flexible stainless steel
appliance connector (4-5 ft [1.2-1.5 m]) or rigid gas supply
line as needed.
Parts Supplied
■Convertible regulator set for 4" WCP Natural gas.
■Single-prong plug/5,000mAmp transformer assembly
■1.5-volt “D” size alkaline battery

Location Requirements

Select a location that provides minimum exposure to wind and
traffic paths. The location should be away from strong draft
areas.
Do not obstruct flow of combustion and ventilation air.
Clearance to combustible construction for built-in and
freestanding outdoor grills:
■A minimum of 24" (58 cm) must be maintained between the
front of the grill hood, sides and back of the grill and any
combustible construction.
■A 24" (58 cm) minimum clearance must also be maintained
below the cooking surface and any combustible construction.
Rotisserie (accessory)*
If you equip your grill with a rotisserie, a 6" (15 .2 cm) minimum
clearance is needed for the rotisserie motor.
A grounded, 3-prong outlet located to the left of the grill is
required. See “Electrical Requirements” section.
*See “Assistance or Service” section to order.
■Tape mea su re
■Small, flat-blade screwdriver
■Flat-blade screwdriver
■#2 and #3 Phillips screwdriver
■Level
■Wrench or pliers
■Pipe wrench
■Scissors or cutting pliers
(to remove tiedowns)
■Noncorrosive leak-
detection solution
■Tape mea su re
■Small, flat-blade screwdriver
■Flat-blade screwdriver
■#2 and #3 Phillips screwdriver
■Level
■Wrench or pliers
■Pipe wrench
■Scissors or cutting pliers
(to remove tiedowns)
■Noncorrosive leak-
detection solution
WARNING
Explosion Hazard
Do not store fuel tank in a garage or indoors.
Do not store grill with fuel tank in a garage or indoors.
Failure to follow these instructions can result in death,
explosion, or fire.
WARNING
Fire Hazard
Do not use grill near combustible materials.
Do not store combustible materials near grill.
Doing so can result in death or fire.