® 30" (76.2 cm) Freestanding Gas Range
PRODUCT MODEL NUMBERS
KGRS205T
Gas supply: This range is
PRODUCT DIMENSIONS
This range is factory set for use with Natural gas. The model/serial rating plate located behind the storage drawer on the
Provide a gas supply line of 3/4" (1.9 cm) rigid pipe to the range location. A smaller size pipe on longer runs may result in insufficient gas supply. With LP gas, piping or tubing size can be 1/2" (1.3 cm) minimum. Usually, LP gas suppliers determine the size and materials used in the system.
NOTE:
If local codes permit, a new CSA
152.4cm) long, 1/2" (1.3 cm) or 3/4" (1.9 cm) I.D., flexible metal appliance connector may be used for connecting range to the gas supply line.
A 1/2" (1.3 cm) male pipe thread is needed for connection to the female pipe threads of the inlet to the appliance pressure regulator.
The supply line must be equipped with a manual shutoff valve. This valve should be located in the same room but external to the range. It should be in a location that allows ease of opening and closing.
Electrical:
*TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.
A
F
A. 28¹⁄₂" (72.4 cm) depth with handle to backguard standoffs.
29" (73.7 cm) depth with handle (KitchenAid models only)
B. 35⁵⁄₈" (90.5 cm) cooktop height (minimum) with leveling legs screwed all the way in*
C. 47¹⁄₈" (119.7 cm) overall height (minimum) with leveling legs screwed all the way in*
D. 29⁷⁄₈" (75.9 cm) width
C
B
D
G
E. 26³⁄₄" (67.9 cm) depth to
background standoffs
F.Model/serial number plate (located behind the storage drawer on the
G. Rating number plate (located behind the storage drawer on the
CABINET OPENING DIMENSIONS
|
| D |
|
| B |
|
| C |
A |
|
|
|
| E |
F |
| G |
|
| M |
| G | N |
| H | |
|
| |
| H | J |
|
| |
K |
| I |
| L | |
|
| |
J |
|
|
*Range can be raised approximately 1" (2.5 cm) by adjusting the leveling legs.
Cabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop height.
IMPORTANT: If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface.
Range may be installed with zero clearance to combustible construction at the rear and on the sides below the cooktop.
A. 18" (45.7 cm) upper cabinet to countertop B. 13" (33.0 cm) upper cabinet depth
C. 30" (76.2 cm) min. opening width
D. For minimum clearance to the top of the cooktop, see NOTE. E. 30" (76.2 cm) min. opening width
F. 3" (7.6 cm) min. clearance from both sides of the range to the side wall or other combustible material
G. 6" (15.2 cm) width of H (area for gas and electric) H. Recommended area for gas and electric installation I. 6" (15.2 cm) height of notched area in H
J. 3¹⁄₄" (8.3 cm) distance from side of range to H K. 3" (7.6 cm) width of notched area in H
L. 3" (7.6 cm) distance from wall
M. Cabinet door or hinges should not extend into the cutout. N. 19" (48.3 cm) height of H
NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet is protected by not less than ¹⁄₄" (0.64 cm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the cooking platform and the bottom of an unprotected wood or metal cabinet.
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation | Ref. W10188242 |
Instructions packed with product. Specifications subject to change without notice. |