rnI

Ipij

7 Remove end cap from Emmiscellaneous parts bag

’ and insert into top of door handle. If you wish to change the door handle insert, slide insert trim into handle. See Custom panel and insert dimensions for exact sizes to cut custom inserts. Insert end cap into top of door handle. Replace refrigerator door handle.

Repeat Steps IO and 11 for the freezer door.

to refrigerator. Check that the power switch is in the “ON”position.

Attach top grille decorative panel assembly to the keyhole bracket on the frame and pull down to secure. If the top grille decorative panel does not fit evenly within frame, the keyhole bracket can be moved side to side by adjusting the bracket screws or the decorative panel bracket can be moved up or down by adjusting the decorator panel bracket nuts.

BEICheck the water

. connections at the bottom of the refrigerator

again for leaking. Any leaking can cause refrigerator and floor damage.

Open both doors. Use

/171two screws to attach n bottom grille to cabinet

Loosen the four height adjustment screws. Adjust the bottom grille to fill the space from the floor to the bottom of the cabinet. Tighten adjustment screws

Put shelves and bins into the refrigerator and

1181 n freezer compartments. Remove protective film from door frame.

Move the ice maker arm into the down position. Set refrigerator and

-1 Remove two nuts from one end of the top panel

/13j q frame. Remove end piece. Slide decorative panel into panel frame. Replace end piece using nuts

Check that

top grille is aligned with top trim on cabinet. Use ten screws to tighten top grille frame

Personal Injury Hazard

Reinstall set screws after door swing is set.

Failure to so could result in personal injury.

Check that doors can

El open freely. If not, the m door stops or hinges

can be adjusted.

To adjust horizontally: Loosen set screw in top and bottom hinges with Allen wrench. Determine the door swing desired. Hold door in that position and tighten the set screws. The doors have stops at 90°, 115” and 137” positions If the door stops cannot be adjusted to clear countertops, the countertops may need to be mitered. (Consult your builder to adjust countertops.)

To adjust vertically: Loosen, do not remove, top and bottom hinge screws. Lift door and bottom hinge to desired position. Tighten bottom hinge screws and then top hinge screws.

freezer compartment controls to the midpoint between ‘COLD” and “COLDEST”. Check that the compressor is operating properly. Check that all five interior lights and one exterior light above dispenser area are working.

Use a drinking glass to

. press ice dispenser bar.

120You should hear the

motor and auger operating. Press the glass against the water dispenser bar. Dispense and discard 2 to 3 quarts of water to remove air from system and rinse tank.

To get the most efficient use from your new built-in refrigerator, read your KitchenAid ’ Use and Care Guide. Keep Ins talla tion Ins true tions and Guide close to built-in refrigerator for easy reference.

Page 10

Page 11
Image 11
KitchenAid KSRF42DT installation instructions RnI