ATo Remove Doors (See Fig. 1) Use caution! Oven door IS heavy
1 Open door completely.
2.Depress finger tab In oven door hinge area. Push tab toward oven. Loft tab away from door liner and slide toward top of oven door.
3Repeat step ? for other side of door.
4.Close door until approximately 5 inches from fully closed posltion.
5.Slide door off the hinge arm assemblies.
6 Repeat steps 1 through 5 for other door on double ovens.
BE SURE THAT PHENOLIC SPACERS AT EACH SIDE OF OVEN
ARE IN PLACE TO PROVIDE PROPER AIR FLOW
BETWEEN CABINET AND OVEN.
BWhen oven has been placed into cabinet; install exterior trim, if used, or the bottom trim strip. Where the exterior trim is to be installed on the oven, omit step C and proceed with the instructions supplied with the trim.
CThe bottom trim strip is placed on lower edge of front frame. This is done by loosening the three screws at the bottom of the front frame. Slide the trim strip under the screw heads until the strip meets the lower corners of the front frame (See Fig. 2). Tighten screws to hold to front frame.
Personal Injury Hazard
Securely fasten wall oven to cabinets using the screws provided (4 screws for a double oven or 2 screws for a single oven). Failure to do so could cause oven to move or tip during use and result in personal injury.
DSecure oven to cabinet with a8 screws provided. Do not overtighten screws. Edge of front frame should be parallel to cabinet or front edge of exterior trim. Disregard any excess screws that are left after all screw holes in front frame have been used.
EInstall unwrapped oven racks in oven.
FReinstall the doors (See Fig. 1).
1 Slide door hinge arms until firmly seated.
2 Lower door to full open position.
3 Push finger tabs to back. Depress the tabs and slide forward.
4 Close and reopen door slowly to make sure it has been replaced properly.
5 Repeat steps 1 through 4 for other door on double oven.
