Klipsch 1000 manual Connections, Care And Cleaning, EU Compliance Information, WEEE Notice

CONNECTIONS

Conventional Connection – Using 20-16 gauge speaker wire, connect the RED “positive” (+) terminal of the LEFT speaker to the RED “positive” (+) terminal of your amplifier’s LEFT chan- nel. Connect the BLACK “negative” (-) terminal of the LEFT speaker to the BLACK “negative” (-) terminal of your amplifier’s LEFT channel. Repeat this procedure for connecting all remain- ing speakers to the appropriate amplifier channels. Refer to Figure 4. Make sure no bare wires from any of the connections touch any other bare wires or terminals as this could cause a short and damage your equipment.

Amplifier Requirements – Klipsch speakers are highly efficient and will work well with a wide variety

of amplifiers. Due to the high output levels Klipsch speakers are capable of reproducing, exercise caution with the volume control. Excessive volume over long periods of time can permanently damage your hearing. Overdriving your amplifier could also damage your speakers. Check with your dealer to make sure your particular amplifier is best suited to your application. We want you listening for a lifetime.

NOTE: The A/V receiver/surround sound processor must be set to “Subwoofer On” and all speakers set to “small”.

The suggested crossover point is 150 Hz. If 150 Hz is not avail- able, use 120 Hz.

CARE AND CLEANING

Your speakers have a durable finish that should only require dry dusting. Avoid use of abrasive or solvent-based cleaners and harsh detergents. The brush attachment of your vacuum or a damp cloth should remove any dust from your speaker grilles.

EU Compliance Information

Eligible to bear the CE mark, Conforms to European Union Low Voltage Directive 73/23/EEC and 2006/95/EC; Conforms to European Union EMC Directives 89/336/EEC and 2004/108/EC.

WEEE Notice

Note: This mark applies only to countries within the European Union (EU) and Norway.

This application is labeled in accordance with European Directive 2002/96/EC concerning waste electrical and electronic equipment (WEEE). This label indicates that this product should not be dis- posed of with household waste. It should be deposited at an appropriate facility to enable recovery and recycling