Getting Started | Preparing the Loudspeaker |
Unpacking
Please follow the unpacking instructions fully and in the order shown below. These loudspeakers are heavy! Do not lift or move these speakers by yourself. Always have someone help you.
1 | Open the carton flaps | 2 | Remove the Grille box |
| Lightly tape each flap to the box |
| Remove the Accessories box |
| with short pieces of tape |
| Remove the Owner’s manual |
| Remove the top packing piece |
| and gloves |
3 | Carefully invert the carton | 4 |
| Lift off the carton | |
|
|
Connection Procedure:
There is a specific procedure to be followed:
•Switch off and unplug the amplifier/s and all source electronics from the mains power.
•Place both loudspeakers in the general area where you want them.
•Place each loudspeaker on its side, in its partial packing, as described in the unpacking instructions.
•Connect each loudspeaker.
•Attach the spikes following the instructions under the “finalizing the assembly” section of this manual.
•Position the loudspeaker cable between the rear spikes.
•Stand the loudspeaker upright, using great care not to damage connecting cables, furniture or the floor.
•Lift off the top packing piece and the protective cloth bag.
•Run both sets of loudspeaker cables to the amplifier.
•Connect the amplifier.
•Finalize the position of the loudspeakers.
•Finally, fit the grilles (if desired).
TAKE CARE NOT TO TOUCH THE DRIVE UNITS WHEN YOU MOVE THE LOUDSPEAKERS AROUND. TO PRESERVE THE FINISH, USE THE PROVIDED GLOVES WHEN HANDLING YOUR LOUDSPEAKERS.
Fitting and Removing the Grilles
5
Lift off the center and base packing pieces
The loudspeaker is ready for connection
The grilles are magnetically attached to the cabinet. Specially designed magnets are housed inside the front wall of the loudspeaker, so that if you wish to operate the loudspeaker with the grilles removed, no grille mounting hardware is visible. This preserves the smooth lines of the loudspeaker.
To fit the grilles: Fit the top grille first and line it up with the top and sides of the cabinet. There is a small lip on the top of the grille that should rest on the top of the cabinet. Now, fit the lower grille, lining up the top of the lower grille with the bottom of the upper grille. You may now remove the top grille if you wish.
Page 4
What’s in the box?
•The grille box contains: one upper grille; one lower grille.
•The Accessories box contains: four long spikes; four short spikes; four spike seats; two
straps: one Allen wrench.
•There is a pair of gloves located in a pocket in the side of the packing carton beside the Owner’s manual.
Identify all the components. If any item is missing or damaged, report this immediately to your Klipsch dealer and the transport contractor for action.
Although operating the
Page 5
