IR230 Infrared Receiver Specifications:
Specifications |
|
Infrared carrier frequency: | |
Indoor reception range: | |
Nominal reception angle: | 50 degrees off axis |
Maximum wire length: | 1000’ (300m) or more with larger |
| gauge wire |
Wire requirements: | 3 conductors, minimum |
| to 200’; |
| |
Power requirements: | Unregulated 12VDC, 40mA |
Dimensions: | 0.6” x 2” (15mm x 50mm) |
Cut out hole dimensions | ½” (12mm) |
Cord length | 75” (2 meters) |
Requires 12VDC power supply, emitter(s) and IR54, or IR55 connection block.
Warranty
Knoll Systems warrants its products sold in the USA and Canada by authorized Knoll dealers to be free of defects in materials and workmanship. This warranty extends for three full years from the date of purchase by the original consumer. Any products returned to Knoll Systems and found to be defective by Knoll Systems within the warranty period will be repaired or replaced at Knoll Systems option, at no charge. Knoll Systems will not be responsible for the actual cost of installation or removal of the product, nor for any incidental or consequential damages. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to you. This warranty gives you specific legal rights. You may have additional legal rights that vary from
Knoll Systems www.knollsystems.com
145 Tyee Drive Point Roberts, WA 98281
12140 Horseshoe Way, Richmond BC V7A 4V4 Telephone: (604)
Made in China Knoll Systems All Rights Reserved
IR230
Peep-hole Infrared Receiver
Installation Instructions v1.2
Warning: To be installed and/or used in accordance with appropriate electrical codes and regulations.
Introduction: Thank you for your purchase of a Knoll IR230 infrared receiver. This receiver features the ability to pick up a remote control infrared signal and relay it on wires to another location up to 1000’ (or more).
Features:
∙Primarily designed to for mounting in panels, doors, cabinets etc.
∙Will relay almost all remote control types (except some B & O and Elite models).
∙Can be connected with almost any
∙Requires very little power. Suggest using PS1202 12 VDC (200 mA) for up to 5 IR21s.
∙Up to 10 or IR230s, IR21s and other compatible models can be connected in a single system.
∙Brass and white color bezel supplied
∙Small and CFL and sunlight ready design
Installation Tips
1.Follow all local electrical & building code requirements.
2.The IR230 is usually mounted in a panels, door, cabinet or plate. It does not normally require a junction box. For easy installation and to ensure reliability, it is suggested that a PS1205 (500 mA) 12 VDC unregulated power supply, IR31 (single) or IR34 (dual) emitters and one of the following: IR54 (decora inwall style, 4 output) or IR55 (tabletop style, 4 output) connection block, be used.
3.Wires can be solid or stranded, shielded or unshielded with a minimum of