
MR164 Keypad
Operating
Instructions
Congratulations and thank you for choosing this Knoll product. The MR164 keypads can control the GSZ67
The MR164 is available with two LCD colors, yellow- green with black lettering and blue with white lettering (model MR164b). Both versions are available with Decora™ style bezel plates in white, almond, black or ivory colors.
The music system consists of:
1.Rooms with stereo speakers, a MR164 keypad or a third party whole house controller and possibly a remote control.
2.One or more GSZ67
3.Stereo source components such as tuners, CD players, satellite dish receivers, cassette decks, and other components.
While the MR164 evolved after years of research, its use is straightforward and direct. Some rooms may have more than one pair of speakers and one or two MR164 keypads or possibly even no keypad.
The music system is controlled by the MR164 keypads, RB12 or universal remote, the source components and possibly a whole home controller. The source components are controlled by their individual remote controls by aiming the remote control at the keypad or infrared receiver and pressing the appropriate remote control button.
Please read about the GSZ67 with the manual shipped with that product.
MR164 Keypad Operation
The MR164 keypad is relatively easy to operate and within a short period of time should be very intuitive.
Please ensure that keys are not pressed too fast as the controller or keypad may be confused. If this happens reset the system powering it off and then on again.
Input | Line 1 |
| |
select | LCD display | ||
button | Line 2 | ||
| |||
Volume | INPUT | Volume UP | |
and DOWN or | |||
select |
| ||
| source select or | ||
button | VOL | ||
sets backlighting | |||
Mute |
| ||
M UTE ALL | ALL button for whole | ||
Button | |||
Infrared |
| house functions | |
OFF | Shut off this room | ||
Receiver | |||
| or shut off whole | ||
|
| house (press for | |
|
| 5 seconds |
Adjusting Backlighting. MR164’s are backlit for easy nighttime operation. To adjust the backlighting make
sure the power for the keypad is on and the MR164 is displaying:
Without pressing any other buttons press the UP or DOWN button to increase or decrease the backlighting illumination. The level selected will remain in the memory even if the power is disconnected.
Turning on a source to this room with the MR164 keypad. After the system is completely installed, if the system is not yet turned on, turn the sources on and then turn the GSZ67 controller amplifier using the front power button on the GSZ67.
After power has been turned on |
| |||
the MR164 keypad will display its |
| |||
System | ||||
software revision followed by |
|
| ||
|
| Off | ||
“Knoll Systems” and then: |
|
| ||
|
To turn a source on in this room press the INPUT button. The volume is always set at about 30% when the room speakers are first turned on. This room will always revert to the source it was switched to when it was turned off last time. To change to another source, see changing sources below.
Turn on a source in this room using the RB12 Remote Control. To turn on a source in this room using the RB12 remote control press the RB12 remote control 1, to 7 button corresponding to which source you want to listen to. You do not need to press the POWER button on the remote first.
Whole house source selection is not available from the RB12 remote.