Wiring: Knoll receive modules (UDR-Quad or UR-Quad) are connected to the US4-Hub with cat 5 unshielded wires using all 8 conductors. Connection is made

with the RJ45 connector (RJ45 plug not supplied). Always use standard cat 5 wiring practices. Using the correct wire pairs and polarity is VERY important. Each cat 5 wire run is a home run and wires cannot be shared with two quad receive modules.

Connection to stereo video source equipment: Connect the four US4 Hub gold RCA jacks with a good quality gold connector four wire component RCA jumper cable to the appropriate three component output and digital audio output jacks on your DVD, dish receiver, D- VHS, VCR, stereo or other equipment. If there is a switched outlet on your output equipment, you may want to plug the PS1202 power supply to the switched outlet.

Make sure a good quality RJ45 8-8 crimper is used to connect the RJ45 connector to the cat 5 wire. Poor crimping and mismatched wires are the most frequent cause of installation problems.

Power requirements: The Knoll US4-Hub comes with a 15 VDC power supply. Each Quad receive module requires a Knoll PS1202 power supply.

Note: The quad receive modules can be either decora in-wall style or enclosure style as desired.

Connecting Quad receive modules on to the Projector, TV or other components: See documentation shipped with the receive units.

Multiple Connection(s): If more than six component receivers are required in a system, multiple US4-HUB’s can be connected together. To wire together a second, third, etc. US4-HUB, connect the LINK OUT of the first US4-HUB to the LINK IN of the second US4-HUB using a short as possible tested cat 5 jumper with RJ45 connectors, using all 8 wires. Connect the LINK OUT of the second US4-HUB to the LINK IN of the third US4-HUB and so on. In this example the second and third hubs do not have RCA jacks connected but do have their PS1506 power supply connected.

IMPORTANT: All of the US4-HUB’s not connected via RCA jacks, but with a cat 5 wire daisy chained from another US4-HUB need to have their LINK switch positioned in the OUT position. The US4-HUB with RCA jacks connected needs to have the LINK switch in the IN position. UR receive units do not have any alterations.

The Knoll send receive system does not have any user adjustments and is completely automatic. If need be, please call our tech line for details at 1 800 566 5579.

This product may contain lead that some states have determined are harmful. Wash you hands after touching this product.

Decora™ is a trademark of Leviton Manufacturing.

Quad Receive

DVD Player

PS1506

 

 

DLP-TV

TO QUAD RECEIVE BALUNS

IN LINK OUT

COMPONENT INPUTS

CAT 5

PS1202

Page 2
Image 2
Knoll US4 warranty Dlp-Tv