9
To turn off the zone either push the keypad button labeled off or the off button on the RB8 remote control.
To turn on the zone on either press the source button or the off button on the remote or keypad. If you press the OFF button the zone will go back to the source selected when it was last shut off. In either case the zone goes to a preselected
To adjust the volume press the volume switch up or down as desired. The relative volume is shown in the led displays on the top.
To temporarily mute the output, press the mute button on either the remote or keypad. It mutes the output in this room.
Equalization (if required).
Equalization cannot be performed from the remote control. To enter the equalization mode press the FNC button. The four source button will have their led’s running in a circular motion. To raise the bass output in this room only push and hold the source 1 button until the desired effect is achieved.
When the maximum bass is selected the OFF button will blink. Do the same with bass down, treble up and treble down. The parameters selected go into memory and are retained even if the power to the system is turned off.
Press the FNC button again to exit the equalization mode.
To go back to a flat frequency response, enter the equalization mode again and when in this mode with the source leds going in a clockwise direction press the MUTE button. The equalization is now flat. Again to exit this mode press the FNC mode and
Knoll Systems service information
The GSZ44 amplifier does not contain any user serviceable parts inside. If you suspect a problem that may require servicing, contact us at www.knollsystems.com/contact.html, or by phone at 800
Troubleshooting
Your Knoll amplifier is designed from