IR100 Infrared Receiver Specifications:
Specifications |
|
Infrared carrier frequency: | |
Indoor reception range: | |
Nominal reception angle: | 50 degrees off axis |
Maximum wire length: | 1000’ (300m) or even more with |
| larger gauge wire |
Wire requirements: | 3 conductors, minimum |
| to 200’; |
| |
Power requirements: | Unregulated 12VDC, 40mA |
Dimensions: | 2.65” x 2.9” x 1.1" |
| (67mm x 74mm x 28mm) |
Requires 12VDC power supply, emitter(s) and IR54, or IR55 connection block.
Warranty
Knoll Systems warrants its products sold in the USA and Canada by authorized Knoll dealers to be free of defects in materials and workmanship. This warranty extends for three full years from the date of purchase by the original consumer. Any products returned to Knoll Systems and found to be defective by Knoll Systems within the warranty period will be repaired or replaced at Knoll Systems option, at no charge. Knoll Systems will not be responsible for the actual cost of installation or removal of the product, nor for any incidental or consequential damages. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to you. This warranty gives you specific legal rights. You may have additional legal rights that vary from
Knoll Systems www.knollsystems.com
145 Tyee Drive Point Roberts, WA 98281
12140 Horseshoe Way, Richmond, BC V7A 4V4 Telephone: (604)
IR100
Tabletop Infrared Receiver
Installation Instructions v1.3
Warning: To be installed and/or used in accordance with appropriate electrical codes and regulations.
Introduction: Thank you for your purchase of a Knoll IR100 infrared receiver. This receiver features the ability to pick up a remote control infrared signal and relay it on wires to another location up to 1000’ (or more).
Features:
∙Tabletop box design available in black and light grey colors.
∙Will relay almost all remote control types (except some B & O models).
∙Can be connected with almost any
∙Requires very little power. Suggest using PS1205 12 VDC 500 mA for up to 10 IR100 receivers.
∙Up to 10 or IR100, IR210, IR220, IR230 and or IR250 can be connected in a single system.
∙Connects with a three wire connector or RJ45 via cat 5 wire.
Installation Tips
1.Follow all local electrical & building code requirements.
2.The IR100 is usually mounted on a tabletop. For easy installation and to ensure reliability, it is suggested that a or PS1205 (500 mA) 12 VDC unregulated power supply, IR31 (single) or IR34 (dual) emitters and one of the following: IR54 (decora inwall style, 4 output) or IR55 (tabletop style, 4 output) connection block, are used.
Made in Canada Knoll Systems All Rights Reserved
